Shelf Bracket Standard 150mm

A single 150mm standard bracket, for a narrow shelf for spices, paperbacks or a bathroom. Hooks into any 32mm pitch upright, ours or anybody else's.

Brackets are where cheap shelving gives itself away. A 2mm pressed bracket will hold a shelf and will also flex enough that the shelf front dips under a row of hardbacks. Ours are 3mm for the standard range and 4mm with a welded gusset for the heavy duty range, and the hooks are formed rather than welded on, which is what stops them opening up over time. Every bracket takes a shelf clip, supplied, so the board cannot slide forward off the front.

Specification

• Dimensions: 150mm deep, 82mm tall at the wall
• Material: 3mm pressed steel
• Finish: powder coated in your chosen finish
• Load rating: 55kg per pair at 600mm centres
• Span and bracket spacing: one bracket per upright per shelf, uprights at 600mm centres or closer
• Adjustability: hooks in and out on the 32mm pitch with no tools
• Suitable walls: brick, block, concrete and timber stud. Plasterboard on dabs needs the long fixing kit, which is a free option at the checkout
• Fixings: not applicable, the bracket hooks into an upright
• Board thickness accepted: 18mm to 40mm
• Shelf clip: supplied, stops the board sliding forward
• Compatible with any 32mm pitch upright
• Weight: approximately 0.14 kilograms
• Sold singly, and in packs of four and ten at the checkout

What you get

• One standard bracket, 150mm
• One shelf clip
• One grub screw and hex key where the bracket takes one

Fitting

Two people, a drill, a spirit level and about two hours for a single wall. Mark the top line first and hang every upright from it rather than measuring up from the floor, because floors are never level and a shelf that follows the floor looks wrong in a way nobody can put their finger on. Fix the first upright, level it, then use a shelf as a straight edge to set the next one. The fixing pack, a paper template and a printed sequence are in the box.